DIY and Entry-Level 3D-Scanner Forum

Hi quangloi37,

what do you want to scan? Perhaps you could upload some images?

Cheers,

Karsten

Hi quangloi37,

unfortunately I can't see your images. Please try it again with appending your images.

Cheers,

Karsten

@kiesel: Could you give me your email? I will send to photos. Because the size of the big photo.

This is the model I used agisoft created.
With such quality is not satisfactory to use my.



http://www.mediafire.com/?220f1klr2qp9vtn

Hi quangloi37, with this kind of model, I think you should try laser scan system, I found the price of Intricad is not too much, about 400$ with the full option : http://www.intricad.com/bin/main/products/triangles.php but the size of the model is about 1~20cm.

You should try this.

I have seen this unchanged since 2011. Do you have experiences with this system?

Karsten

Sorry, I have no experience with this ,but I think with this kind of object and appropricate cost, this system maybe suitable

Theo tôi nghĩ quét Laser đó không thể tốt bằng Structured Light Scanning

I think the resolution of laser scanning is better than the Structured Light Scanning, so the quality of scanner is better.

I think the quality of photoscan file that you uploaded on mediafire is fine (Though I don't know the size of this object, but I think the quality is ok), but some small details is missing.