Hi!
Welcome to the forum
This is what you need:
Attachment:
VirtuCube_V01_Wiring.JPG [ 77.88 KiB | Viewed 3904 times ]
Please note, that you do not need the button anymore. Just wire the servo.
| DIY and Entry-Level 3D-Scanner Forum http://www.diy3dscan.com/ |
|
| Wiring Diagram for Arduino http://www.diy3dscan.com/viewtopic.php?f=8&t=142 |
Page 1 of 1 |
| Author: | Warlock [ Fri Jun 21, 2013 3:04 pm ] |
| Post subject: | Wiring Diagram for Arduino |
Hi, I am very new to this. I now have have all the components ready to build my Virtu-cube scanner including the printed parts. However I do not have the wiring diagram for the turntable. Please could you tell me where I can find this so that I can get up and running. Thank You. Dominic |
|
| Author: | virtumake [ Fri Jun 21, 2013 8:49 pm ] |
| Post subject: | Re: Wiring Diagram for Arduino |
Hi! Welcome to the forum This is what you need: Attachment: VirtuCube_V01_Wiring.JPG [ 77.88 KiB | Viewed 3904 times ] Please note, that you do not need the button anymore. Just wire the servo. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|