DIY and Entry-Level 3D-Scanner Forum

Hi everyone,

First of all, I'm enjoying reading through this forum for the first time. Also, I'm just familiarizing myself with Artec Studio 9, and I have a few questions.

It looks like I'm getting pretty decent mesh results, but unlike most people that I've seen on this forum, my deliverable won't be a 3D printed model, but rather a .OBJ or .WRL mesh that will be imported into other software solutions for animations and measurements.

Does anyone have a way of applying texture to a model inside Artec Studio 9 that has been registered, fused, simplified, and smoothed?

Additionally, I've been trying to import a meshed .OBJ file into Artec Studio 9 to perform some post-processing, but it looks like the texture maps are lost on import. Basically the .OBJ file is meshed with texture in a 3rd party software, but once the file is exported out of that software, and then imported into Artec Studio 9, it looks like Artec Studio just loses the texture information.

Any thoughts/assistance will be much appreciated.

Thanks!