| DIY and Entry-Level 3D-Scanner Forum http://www.diy3dscan.com/ |
|
| Firmware Update for Carmine 1.08, Asus Xtion http://www.diy3dscan.com/viewtopic.php?f=10&t=141 |
Page 1 of 1 |
| Author: | virtumake [ Thu Jun 20, 2013 6:13 pm ] |
| Post subject: | Firmware Update for Carmine 1.08, Asus Xtion |
Primesense published a firmware update for their Carmine 1.08 and compatible devices like the Asus Xtion Pro. I did the update, nothing special happened  Update on your own risk. Make sure to have the old firmware as well, in case the update fails and your scanner must be reset to the old version. http://www.primesense.com/updates/?id=1858 |
|
| Author: | Scantastic [ Thu Jun 20, 2013 10:31 pm ] |
| Post subject: | Re: Firmware Update for Carmine 1.08, Asus Xtion |
virtumake wrote: Primesense published a firmware update for their Carmine 1.08 and compatible devices like the Asus Xtion Pro. I did the update, nothing special happened Update on your own risk. Make sure to have the old firmware as well, in case the update fails and your scanner must be reset to the old version. http://www.primesense.com/updates/?id=1858 Will the upgrade work with the 1.09? They claim it helps with USB 3 connectivity, which I have had a problem with using my Carmine. |
|
| Author: | Toffer [ Sun Aug 18, 2013 3:18 am ] |
| Post subject: | Re: Firmware Update for Carmine 1.08, Asus Xtion |
I just bought a laptop so I could use the scanner remotely, and now I can't seem to get the sensor to connect. I've loaded both Skanect 1.3 and 1.5 and neither acknowledge the sensor. It's a primesense Carmine 1.082 Does anybody know how to manually find and load the needed drivers if that's what I need to do? Also, does the new firmware play any role in this? My PC is a dell precision m2400 with win7 ultimate 32 bit OS centrino2 Thanks! |
|
| Author: | virtumake [ Sun Aug 18, 2013 5:17 am ] |
| Post subject: | Re: Firmware Update for Carmine 1.08, Asus Xtion |
Did you install the OpenNI drivers? This is the link to the 64bit version: http://www.openni.org/openni-sdk/?downl ... -2.1.0.zip please make sure that Skanect and OpenNi are both either 32bit, or 64bit. |
|
| Author: | Toffer [ Mon Aug 19, 2013 2:27 am ] |
| Post subject: | Re: Firmware Update for Carmine 1.08, Asus Xtion |
I finally figured it out. I had done what you recommended and for some reason it didn't take the 1st time. I may have had the sensor plugged into the wrong usb port (the port said usb with a little lightning bolt next to it). I really don't know if that was the problem or not. Anyway, I disabled the driver from the 1st attempt and reloaded the driver again with the camera in a normal usb port and it worked. Thanks for your help. Soon I hope to post some projects. I have the Carmine 1.08, so I'm going to try some larger objects. Has anybody else been using the 1.08? Just curious. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|